Walnutport PA Commercial Refrigeration

Arrived on, 7/17/23- Checked in with manager. Turned fryer on to test operation. Pilot lights but burners do not. Spchecked relay board. Side on light is lit but heat demand isn’t even with controller calling for heat. Removed relay board and noticed the insulation paper wasn’t there and the board was scorched in the back. Asked staff if the fryer even made noise while firing up and they said it made a chattering sound. Inspected pilot assy, ignition cable, high limit and gas valve, all of which tested properly. Will need to return with new relay board. Returned on, 7/20/23 Dan Checked in with MOD. Shut off middle fryer. Lowered controller to access relay board. Removed and discarded damaged relay board and installed new one relay board in its place. Wired in and secured controller back in place. Powered fryer on to test. Fryer pilot lots followed by the main burners. Allowed fryer to heat for a bit to make sure setpoint was maintained. Fryer is back up and running. Job complete.

Arrived at location on 8/4/22 - Pulled air box to remove top orifices. Cleaned both. Put all back together and turned on. When it reached 400degrees top burners lit and inside burner needed air adjustment. Adjusted so burner was glowing orange. Observed for 20 minutes and no errors. Unit is operational job complete.

Checked Pit Gas Fryer unit gas pressure 9.5 max. noticed runner tube for burner clean out not lighting. tested gas pressure at orifice 0 tested supplied to valve had 9.5. valve had 24v to it but not opening. turned pilot flame up. unit came to 353 set to 353. all burners lit. noticed burner flames sometimes slow opening like 1/2 pressure then next time will open all the way intermittently. unit is at 353 degrees. and I never saw error. unit operational ? but requires parts. 3-26-21 Turned gas off and removed combo valve and small burner cleaning valve. replaced both valves turned gas on tested for leaks, none present. turned unit on, once air bled out pilot came on and went thru burner clean cycle. then main burners came on and heated to set point 360 and cycled off. watched cycle several times and valve was opening and closing fast and definite. unit is operational job complete.

Manager said both fryers don't fill all the way and the filter times are wrong. Removed filter pipe clean out plug. It was clogged. Cleaned and reinstalled. Did a filter cycle on both fryers. Drained ok. Oil returning is strong. Pump/motor sounds normal. No strange noises. Oil returned normally. Did the Oil Quality check ok. Heated back to set temps. The filter times are off because the time is not set correctly. It was off by 4 hours. Reset time in settings. Time now set correctly. Back in service.